If you wanna add some beach charm to your décor, make this cool pendant light! You’ll need clean razor clam shells, a small rotary drill, a scrap board on which you can drill, a pendant fixture, light wire and clippers. Set your drill at Level 3, then place the bit about 1/4 inch from the end of the shell. Make sure your shells are all facing the same way when you make the holes so that the finished lamp will lie right. Drilling all the holes took no more than 10 minutes. Cut a 2-foot section of wire and thread it through the holes one shell at a time, making sure they’re all facing the same direction. Finish the lamp reading in the source.
